Altera Nios II Instrukcja Użytkownika Pobierz pdf (Strona 13)

Altera Corporation 1–5

May 2007 Nios II Development Kit Getting Started User Guide

Getting Started

Figure 1–1. Nios Development Board with Power, LCD,& USB-Blaster Connections

To set up the Nios development board, perform the following steps:

1. Remove the Nios development board from its anti-static shipping

bag. Take care not to expose the board to electrostatic discharge

(ESD) during setup or use.

2. Place the board legs-down on a flat surface. Orient the board as

shown in Figure 1-1 with the dual 7-segment LEDs (U8 and U9)

closest to you.

3. Connect the LCD module ribbon cable to connector J12, as shown in

Figure 1–1.

1 Be sure to connect pin 1 on the LCD module to pin 1 of J12

by aligning the triangular marks on the ribbon cable header

with the locations of pin 1 on the LCD module and the J12

header. Pin 1 of the J12 header is labeled on the printed

circuit board.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Brak uwag

Altera Nios II Instrukcja Użytkownika Strona 13