Altera Signal Integrity Development Kit, Stratix V GX Edi Instrukcja Użytkownika Pobierz pdf (Strona 49)

Appendix A: Programming the Flash Memory Device A–5

Restoring the MAX II CPLD to the Factory Settings

July 2012 Altera Corporation Transceiver Signal Integrity Development Kit

Stratix V GX Edition User Guide

f To ensure that you have the most up-to-date factory restore files and information

about this product, refer to the Transceiver Signal Integrity Development Kit,

Stratix V GX Edition page of the Altera website.

Restoring the MAX II CPLD to the Factory Settings

This section describes how to restore the original factory contents to the MAX II CPLD

on the transceiver signal integrity development board. Make sure you have the Nios II

EDS installed, and perform the following instructions:

1. Set the board switches to the factory default settings described in “Factory Default

Switch Settings” on page 4–2.

1 Setting the switch S7.6 (MAX BYPASS) to open (1) includes the MAX II

device in the JTAG chain. Setting the switch S7.6 (MAX BYPASS) to closed

(0) removes the Max II device from the JTAG chain.

2. Launch the Quartus II Programmer.

3. Click Auto Detect.

4. Click Add File and select

<install dir>\kits\stratixVGX_5sgxea7nf40_si\factory_recovery\max2.pof.

5. Turn on the Program/Configure option for the added file.

6. Click Start to download the selected configuration file to the MAX II CPLD.

Configuration is complete when the progress bar reaches 100%.

f To ensure that you have the most up-to-date factory restore files and information

about this product, refer to the Transceiver Signal Integrity Development Kit,

Stratix V GX Edition page of the Altera website.

1 2 ... 44 45 46 47 48 49 50 51 52

Brak uwag

Altera Signal Integrity Development Kit, Stratix V GX Edi Instrukcja Użytkownika Strona 49