Altera Active Serial Memory Interface Instrukcja Użytkownika Strona 21
- Strona / 36
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Protect a Sector on the EPCS/EPCQ/EPCQ-L Device
Use the sector_protect signal to instruct the IP core to protect a sector on the EPCS/EPCQ/EPCQ-L
device.
Figure 5: Protecting a Sector
This figure shows an example of the latency when the Altera ASMI Parallel IP core is executing the sector
protect command. The latency shown does not correctly reflect the true processing time. It shows the
command only.
This command writes the EPCS/EPCQ/EPCQ-L status register to set the block protection bits.
The block protection bits show which sectors are protected from write or erase, and provide
protection in addition to that provided by the wren signal.
You can set the block protection bits in the EPCS/EPCQ/EPCQ-L status register to protect those
sectors that contain configuration data, and are not intended for general-purpose memory usage.
Ensure that the 8-bit code is available on the datain[7..0] signal before asserting the
sector_protect and wren signals. The IP core registers the sector_protect signal at the
positive edge of the clkin signal.
The IP core asserts the busy signal as soon as it receives the sector_protect signal. The busy
signal remains asserted while the EPCS/EPCQ/EPCQ-L status register is written.
If the wren signal has a value of zero, the IP core will not carry out the sector_protect signal,
and the busy signal remains deasserted.
Note:
If you keep the wren and sector_protect signals asserted while the busy signal is
deasserted after the IP core has finished processing the sector protect command,
the IP core re-registers the wren and sector_protect signals as a value of one and
carries out another write status register operation. Therefore, before the IP core
deasserts the busy signal, you must deassert the sector_protect signal.
The IP core uses only bits 2 to 3, or 2 to 4 for EPCS devices, and 2 to 5, or 2 to 6 for EPCQ/EPCQ-
L devices out of the 8 bits for block protection. The rest of the bits have other meanings for the
ASMI operation, and cannot be overwritten by the sector protect operation. Whenever the input
address is in a protected sector, the IP core omits the operation and the busy signal remains
deasserted.
UG-ALT1005
2014.12.15
Protect a Sector on the EPCS/EPCQ/EPCQ-L Device
21
Altera ASMI Parallel IP Core User Guide
Altera Corporation
Send Feedback
Powiązane produkty i podręczniki dla Urządzenia pomiarowe Altera Active Serial Memory Interface
Urządzenia pomiarowe Altera I/O Phase-Locked Loop (Altera IOPLL) IP Core Instrukcja Użytkownika
(11 strony)
(11 strony)
Urządzenia pomiarowe Altera Embedded Systems Development Kit, Cyclone III Edit Instrukcja Użytkownika
(82 strony)
(82 strony)
Measurement MS-4004 Backlit digital gauge with metal body manuales
Manuales del propietario y guías del usuario para Accesorios para el agua Measurement MS-4004 Backlit digital gauge with metal body.
Ofrecemos 1 manuales en pdf Measurement MS-4004 Backlit digital gauge with metal body para descargar gratis por tipos de documentos: Manual de usuario
Komentarze do niniejszej Instrukcji