
6–16 Chapter 6: Board Test System
Using the Board Test System
Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation
Stratix V GT Edition User Guide
The Molex Tab
The Molex tab allows you to run a x4 backplane loopback test through the Molex
connector. Figure 6–8 shows the Molex tab.
1 No external loopback board is provided. A loopback backplane can be purchased
from Molex.
The following sections describe the controls on the Molex tab.
Status
■ The Status control displays status information during the loopback test. For
details on this control, refer to “Status” on page 6–11.
Port
The Port control allows you to specify the type of test to run on the Molex port. The
following Molex port test is available:
■ Molex x1 Transceivers
Figure 6–8. The Molex Tab
Komentarze do niniejszej Instrukcji