Altera Video and Image Processing Suite Instrukcja Użytkownika Strona 235
- Strona / 310
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Signal Direction Description
control_write Input control slave port Avalon-MM write signal. When you
assert this signal, the control port accepts new data from
the writedata bus.
control_writedata Input control slave port Avalon-MM writedata bus. The IP
core uses these input lines for write transfers.
Scaler II Control Registers
The control data is read once at the start of each frame and is buffered inside the IP core, so the registers
can be safely updated during the processing of a frame.
Table 17-5: Scaler II Control Register Map
The coefficient bank that is being read by the IP core must not be written to unless the core is in a stopped state.
To change the contents of the coefficient bank while the IP core is in a running state, you must use multiple
coefficient banks to allow an inactive bank to be changed without affecting the frame currently being processed.
The Scaler II IP core allows for dynamic bus sizing on the slave interface. The slave interface includes a 4-bit byte
enable signal, and the width of the data on the slave interface is 32 bits.
Note:
The N
taps
is the number of horizontal or vertical filter taps, whichever is larger.
Address Register Description
0 Control
• Bit 0 of this register is the Go bit, all other bits are unused.
Setting this bit to 0 causes the IP core to stop the next time
control information is read.
• Bit 1 enables the edge adaptive coefficient selection—set to
1 to enable this feature.
• Bit 2 enables edge adaptive sharpening—set to 1 to enable
this feature.
1 Status Bit 0 of this register is the Status bit, all other bits are unused.
• It is set to 0 if the IP core has not been started.
• It is set to 1 while the IP core is processing data and cannot
be stopped.
2 Interrupt This bit is not used because the IP core does not generate any
interrupts.
3 Output Width The width of the output frames in pixels.
4 Output Height The height of the output frames in pixels.
5 Edge Threshold Specifies the minimum difference between neighboring pixels
beyond which the edge-adaptive algorithm switches to using
the edge coefficient set. To get the threshold used internally,
this value is multiplied by the number of color planes per
pixel.
17-14
Scaler II Control Registers
UG-VIPSUITE
2015.05.04
Altera Corporation
Scaler II IP Core
Send Feedback
- 101 Innovation Drive 1
- San Jose, CA 95134 1
- Contents 2
- Feature Support 7
- Release Information 9
- Device Family Support 10
- IP Core Mode Latency 11
- Interfaces 28
- Video Formats 29
- D0 D1vid_data 32
- Signal Name Description 33
- Avalon-ST Video Protocol 34
- Video Data Packets 38
- Symbol transmitted first 39
- Symbol transmitted last 39
- Plane for even rows 40
- Plane for odd rows 40
- Control Data Packets 42
- Parameters 43
- Description 43
- Type Width Height Interlacin 43
- Order Symbol Order Symbol 45
- Ancillary Data Packets 46
- Packet Propagation 46
- Parameter Name Value 47
- Signal Width Direction 47
- Packet Transfer Examples 48
- Parameter Value 50
- Avalon-MM Slave Interfaces 52
- Avalon-MM Master Interfaces 55
- Related Information 56
- Getting Started 57
- OpenCore Plus IP Evaluation 59
- Control Port 60
- Format Description 61
- Interrupts 64
- Generator Lock 68
- Underflow and Overflow 70
- Timing Constraints 71
- Handling Ancillary Packets 71
- Modules Description 75
- Address Register Description 100
- UG-VIPSUITE 105
- 2015.05.04 105
- 2D FIR Filter IP Core 106
- Coefficient Precision 107
- Parameter Value Description 108
- 2D FIR Filter Signals 109
- Signal Direction Description 110
- Video Mixing IP Cores 112
- Alpha Blending 113
- Video Mixing Signals 116
- 20 Input 3 enable 121
- Chroma Resampler IP Core 122
- 4:4:4 to 4:2:2 123
- 4:2:2 to 4:4:4 123
- Vertical Resampling (4:2:0) 124
- Chroma Resampler Signals 126
- Video Clipping IP Cores 127
- Video Clipping Signals 130
- Color Plane Sequencer IP Core 135
- Rearranging Color Patterns 136
- Splitting and Duplicating 137
- Subsampled Data 138
- Color Plane Sequencer Signals 139
- IP Cores Feature 141
- Input and Output Data Types 142
- Color Space Conversion 142
- Operands 145
- Control Synchronizer IP Core 153
- Control Synchronizer Signals 157
- Deinterlacing IP Cores 160
- Deinterlacing Methods 161
- Bob with Scanline Duplication 162
- Motion-Adaptive 162
- Sobel-Based HQ Mode 164
- Frame Buffering 165
- Types Description 166
- Frame Rate Conversion 167
- Altera Corporation 168
- Send Feedback 168
- Deinterlacing Signals 176
- Register Address 190
- (Decimal) 190
- Register Suggested 190
- Settings 190
- Comments 190
- Tuning Motion Shift 191
- Frame Reader IP Core 192
- Frame Reader Signals 194
- Frame Buffer IP Cores 198
- Double Buffering 199
- Triple Buffering 199
- Locked Frame Rate Conversion 200
- Color Format 201
- Frame Buffer Signals 206
- Gamma Corrector IP Core 214
- Gamma Corrector Signals 215
- Interlacer IP Core 218
- Interlacer Parameter Settings 219
- Interlacer Signals 219
- Interlacer Control Registers 221
- Scaler II IP Core 222
- Bilinear Algorithm 223
- Double-Buffering 226
- Scaler II Parameter Settings 230
- Scaler II Signals 233
- Scaler II Control Registers 235
- Video Switching IP Cores 237
- Mixer Layer Switching 238
- Video Switching Signals 239
- Test Pattern 243
- Trace System IP Core 253
- Trace System Signals 255
- Trace Within System Console 258
- TCL Shell Commands 259
- Command Arguments Function 260
- Packet Visualization 263
- Monitor Settings 264
- Subscribe 269
- Avalon-ST Video Class Library 270
- Class Description 272
- Running the Tests 275
- Video File Reader Test 278
- Example Test Environment 281
- Video Field Life Cycle 282
- Constrained Random Test 283
- Code for Scoreboards 285
- Code for to_grey Function 286
- Complete Class Reference 287
- Method Call Description 288
- Member Description 288
- Raw Video Data Format 299
- Y 410 / A 2R 10 G 10 B 10 301
- Additional Information 306
- Date Version Changes 307
- How to Contact Altera 310
Powiązane produkty i podręczniki dla Urządzenia pomiarowe Altera Video and Image Processing Suite
Urządzenia pomiarowe Altera DSP Development Kit, Stratix V Edition Instrukcja Użytkownika
(74 strony)
(74 strony)
Urządzenia pomiarowe Altera Transceiver Signal Integrity Development Kit, Stra Instrukcja Użytkownika
(42 strony)
(42 strony)
Urządzenia pomiarowe Altera Transceiver Signal Integrity Development Kit, Stra Instrukcja Użytkownika
(58 strony)
(58 strony)
Urządzenia pomiarowe Altera Cyclone II EP2C35 PCI Development Board Instrukcja Użytkownika
(50 strony)
(50 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji